Multiparameter Chlorine Analyzer for Hot Water
- Home
- Hot Water Multiparameter Chlorine Analyzer
MP-HOT
Multiparameter Free Chlorine Analyzer for Legionella Water Treatment
Unlike any other sensor on the market, this sensor can measure all necessary species for control and reporting. It achieves this with no reagents, no membranes, and minimal maintenance.
Legionella compliance and control through 24-hour monitoring of chlorine levels in hot water systems is not only practical but also necessary in certain locations.
Installed virtually anywhere - direct-in-pipe (NSF-61 Approved)
Not affected by changes in flow or pressure
No waste stream saves 70,000 gallons of water
Savings of $490 in water and $950 in energy.
24 hour monitoring and compliance
Measures 4 ASHRAE/CDC recommend parameters chlorine, pH, conductivity, temperature
Monochloramine sensor is available
The sensor utilizes bare electrodes without membranes and is self-cleaning, allowing for extended intervals between calibrations. Very low maintenance, as well as flow and pressure independence, are unique aspects of this technology. The sensor is both temperature and pH-compensated. All Halogen Sensors are NSF-61 certified for safe exposure to drinking water.
Why you need it:
Other sensors require a 70,000 waste stream. Halogen MP-HOT can go directly to point-of-use locations to measure parameters throughout the hot water loop. You can save thousands of dollars in reagents and labor with the MP-HOT system from Halogen Systems, Inc.
